- Foam Party Branding
- >
- Foam Cannon Wrap
Foam Cannon Wrap
Custom 3M Foam Cannon Wrap.
This is a 2mil film 3M vehicle wrap material.
*Send your logo [email protected]
Cannon Wrap Installation Instructions
(Make sure sticker and cannon tube are room temp.)
Take the white tube off the fan and the black plastic trim.
1. Do a dry fit. (Meaning just wrap around to see how it looks and where the top center will be. That will help you to show where to start. There will be some overlap on the bottom.
2. Once you have determined where you want the sticker to be. You will start from the bottom and go around. Use a spray bottle with water and few drop of baby shampoo. This will help the sticker not adhere until you use the squeegee to push it out.
3. Use a few inches at a time. You are good to just cover your screws that hold the cone on the inside.
4. Take your time and keep the cannon wet as you are putting the sticker on.
5. If you get a bubble use a needle to put a hole and the squeegee to rub over to get out.